Description
Splitter Scuff Blocks
AKA – Splitter Biscuits, Splitter Protectors, Skid Blocks
Protect your splitter and prevent porpoising by adding splitter scuff blocks to the bottom of your splitter. Splitter blocks ensure a minimum airgap and protect your splitter from directly contacting the ground.
Ultra abrasion resistant and aerodynamic splitter blocks designed to protector your splitter for race or street applications. Splitter scuff blocks provide much needed protection of your splitter from contact wear from asphalt, concrete, rumble strips, curbs and even off-track excursions. Made in the USA from AR ultra abrasion resistant steel.
Splitter blocks are installed using up to three 1/4-20 bolts with 0.75″ spacing. Just drill three holes into the splitter, insert bolts with washers through the top side of the splitter and screw into these blocks with readily available 1/4-20″ hardware. Blocks should be installed behind the leading edge of the splitter typically on the sides and the front of the splitter where contact is most likely.
These were designed to protect our splitter on our endurance racing Miata to minimize aero impact and weight while maximizing abrasion resistance to last through the most punishing conditions.
Physical Properties:
Material: Abrasion Resistant “AR” Steel (Bullet Proof)
Length: 3.00″
Height: 0.38″
Width: 0.75″
Bolt Pattern: 3 x 1/4-20 Thread – 0.75″ Spacing.
Weight: 1.9oz, 54 grams each.
Includes:
4 x AR Steel Splitter Blocks ( 1 Set = 4pcs)
